 |
BOTH SIDES
ADHESIVE SELF AMALGAMATING BAND |
|
  [back]
|
It perfectly adheres on steel, aluminium, glass and on most of
plastic materials used in the building sector, such as : fiberglass
polycarbonate, Plexiglas, PVC section bars. It can be used for the installation of
insulating panels on shaped plates or on other supports. Very good performance on cupolas
and skylights. It is usually applied as a corrosion proofing covering of steel mains or
pipes to be laid underground. Highly recommended on irregular surfaces, such as special
pipes, Te, spigot joints, etc. Suitable for the preparation of big joints, too, where
elastic and filling material are needed.
INSTRUCTIONS FOR USE: For a strong and lasting fixing, the surface must
be dry and clean. Use a bituminous primer type FACOT ADHESIVE PRIMER only if surfaces are
not perfectly clean or are too much wrinkled. |
|
|
| On flat surfaces, use a sharp cutter, a pair of scissors and a little roll
to press the product (in particular the overlapped part). When used on pipes it is better
to stretch the band to adapt it to the surface to be covered. Within certain limits, the
band is self-healing. The product must be applied at a temperature higher than 5°C.
Protect the product from UV rays for a few months after the application. TECHNICAL
DATA: Working temperature: - 20 + 75 °C - Thickness: 1.5 mm - Dielectric
strength: > 20 Kv/mm - Shear peel test on metal (23 °C): 16.5 N/cm - Longitudinal
tensile strength: 47 N/m2 , transversal: 35 N/m2. |
|